We have made lots of improvements and upgrades on Escape. Of
course when I say “we”, I really mean Shay. He has been very busy.
Below is a list of some of the major projects he has worked
on summer 2011.
- Removed
the 4 8D starting batteries so he can work on the outboard side of the
engines.
- Installed
1 8D starting battery just inside the port transmission, which starts both
engines.
- Replaced
a failed salon heat pump.
- Moved
the fire extinguisher to the back wall to the right of the battery charger. He had to move the battery charger
2" to the left to make room for the fire extinguisher. All this was
done to make room for the new house batteries and inverter.
- Installed
a new house bank of 6 AGM 8L16 batteries on the shelf where the fire extinguisher
used to be. This gives us 1245 amp
hours at 12 volts which translates to lots of power.
- Installed
new 2800 watt inverter/charger that charges the house bank at 130
amps. The old charger still charges
the generator battery and starting battery as well as the new house bank.
- Installed
a remote house bank monitoring system, that can also remote control the
inverter and charger.
- Reduced
the size of the generator start battery from an 8D to group 31.
- Installed
new dual Racor engine fuel filters.
- Installed
a fuel transfer pump with a Racor filter to make a simple fuel polishing
system that can also be used to move fuel from one tank to another.
- Installed
a large raw water wash-down pump and plumbed it to the bow so we now have
fresh or salt water to clean the anchor chain. The new pump does a very good job of
pumping lots of water at a high pressure.
- Converted
all the interior lights to LEDs.
- Installed
a new WIFI amplified antenna and wireless router. We can now get WIFI from miles away.
- Removed
fluorescent light fixtures in the engine room and replaced them with very
low profile fixtures. Lots of light
and very low profile which means fewer things to bump into.
- Put a
piece of plastic lumber under the swim platform to make it harder for the
dingy to get under the platform.
- Installed
a TV in the bedroom.
- Installed
a muffin fan that runs when the refrigerator is running to ventilate the
cabinet housing the refrigerator.
- Installed
galvanic Isolator.
- Installed
3 220 watt solar panels over flybridge bimini top for a total of 660
watts.
- Reused
cabinet from engine room to create new computer desk.
- Installed
a new bimini top and side curtains for our flybridge.
- Finally
figured out how to transfer waypoints and routes from Coastal Explorer
running on PC to Raymarine chartplotter.
- Got
ready for a hurricane haul-out.
While the boat was out of the water for Hurricane Irene he
did some more major projects.
- Cleaned
and sanded the bottom of boat and repainted with anti-fouling paint.
- Compounded
and waxed the hull from the waterline to the deck.
- Cleaned
old paint off props and recoated with Prop-Speed at $7500 a gallon.
Luckily, we only needed 4 ounces!
When all this was finished we were exhausted and broke. All
this work was for one reason… so we could start traveling again and head south
for the winter.
This should have been posted when we left for Marathon, but
I didn’t. That’s ok because now I can brag on some of the upgrades:
- The
solar panels have been fantastic. We went for 6 months without shore power.
Usually when you tell someone that you also have to say, “but we ran our
generator 2 or 3 or 4 or how ever many hours a day to charge the batteries”.
We never HAD to run ours to charge batteries. We did run it just to make
sure it worked and at first to heat water for showers. Shay did a
temporary “fix” to we could heat water with solar, so after that, we only
ran the generator every couple of weeks to keep it working. We’d plan
something to cook in the oven those times to get the most we could out of
the generator.
- The
new batteries and charger work together with the solar panels and made
life on our boat great.
- The
fuel transfer pump kept our fuel clean and prevented fuel filter problems.
We could also move fuel from the tank under our bed to another tank with a
working site gauge.
- The
new placement of batteries made engine room work easier. We also got more
storage space. He put removable containers where the batteries were.
- The
high pressure raw water wash down pump works great when bringing up the anchor.
Most of the time when you bring up the anchor is has sand, grass, or mud
on it. The old fresh water wash down pump had very low pressure, took
forever to get the anchor clean, and used our fresh water. This makes the
job faster and does a much better job.
- Changing
the lights all over the boat has saved money and in the engine room
headroom.
- The
fan he added to the refrigerator space means the refrigerator runs less
which means it uses less energy and will hopefully last longer.
- The TV
in the bedroom means if I want to watch something and he’s on the computer
or phone I can go downstairs and not bother him.
- All
the cleaning, waxing, and painting made the boat move thru the water
smoother and saved gas.
It was a long, hot, expensive time, but it looks like it was
worth it.
|
This angle shows the new tool chest. The drawer that was here is now the computer desk. |
|
You can see the storage area where the batteries were. |
|
New batteries |
|
Crawling into a cubby looking for ??? |
|
Cleaning the rudders |
|
New bottom paint |
|
Cleaning sea chest |
|
Shay and Ken applying Prop Speed. Its a 2 man job. |
|
"Golden Prop" |
|
More painting |
|
Applying Rejex |
|
The instructions said "removes effortlessly". Crap |
|
Plastic lumber under swim platform to keep dinghy out. |
|
Drilling a hole in my boat for the salt water washdown pump. |
|
Beautiful boat. Will it every look this good again? With Shay as the capatin, I'd say "YES'. |
We’re back in Morehead City now. More projects going on even as we speak…